So we did this a while back but I never posted it…partially because it was in the winter and I was pretty ashamed that we had no grass at that point.  Our yard looked super white trashy at the time, but after putting a pool in the middle of our front yard and waddling my huge pregnant booty out there in a bikini, I figure that my white trashiness has reached the point of no return, so here goes.

The common question seems to be “Why the front yard?” Because the dogs are in the back and it would take them all of 3 seconds to have torn this thing apart.

Anyways, we went down to our local BBQ store to look for a couple of thermometers to add to the lid of our 22.5″ Weber kettle so we could monitor the temperature and have better control over our dual zone cooking.  We picked up two thermometers and a silicone sealant safe for high temperatures.  You are also going to need a power drill, marking pen, and possibly measuring tape(if you want things to be all nice and symmetrical)

We (meaning Derek, I just stood there and took pictures), measured out the desired distance and drilled a pilot hole, which is a small guiding “starter hole” before you start putting holes in your grill lid with a giant drill bit.

We also noticed that there was a small notch on the back of the thermometer, to keep it from turning I am assuming? Not really sure, but it required the drilling of yet another hole as well.

It doesn’t have to be pretty, it just has to work

Put your sealant around the top of the holes and install your thermometer.  Then seal up around the inside of the grill and you are done!

Let this dry for at least 24 hours before using, and enjoy your new customized Weber grill!